English Français Español
ZH-SB1 in the electric pallet truck (hydraulic forklift) application, generally installed in the four corners of the scale platform, can be equipped with connected instrument accurate reading.
View More
The selection of material and shape of weighing sensor has several aspects: 1. Weighing sensor material: alloy steel, stainless steel, aluminum alloy, steel alloy 2 Weighing sensor shape: single point type, spoke type, single shear beam type, double shear beam type, bellows, pressure type, column type, torsion ring type, bridge type, S type, pull type and other shapes. Environmental adaptability selection of weighing sensor: Sensors used in we...
Torque sensor technology is becoming more and more mature, but its development has gone through three stages: The first stage is the generation of measurement technology. In 1678, Robert Hooke described Hooke’s Law, the proportional relationship between the elongation of a material and the tension of the material in question. Moreover, the bridge circuit made it possible to measure small changes in voltage. The second stage rotary torque...
The use and installation of a single weighing sensor is relatively simple and can be operated directly. There are few matters needing attention, but what is used more is the combination of multiple weighing sensors. If multiple sensors are installed, there are more problems needing attention. For example, a high-precision electronic weighing instrument rarely uses a weighing sensor, often two or three more sensors to form the sensor sys...
Strain gauge pressure sensor is usually four-wire system (excluding shielded wire), usually red, black, green and white four wires, in which red and black are positive and negative power supply (excitation), green and white are positive and negative signal (output). Use a multi-meter electrical block, measure the impedance between the red line and the black line and the impedance of the green line and the white line, see whether the impedance ...
Prepare the strain gauge Before mounting, check the appearance of the strain gauge and measure the resistance value. Appearance inspection can be carried out with the naked eye or with the aid of a magnifying glass. The purpose is to observe whether the sensitive grid has rust spots, defects, alignment, damage to the base and covering layer, and whether the lead is intact. The purpose is to check whether there is a circuit break or short cir...
About ZH-LP9 customer site installation sample
A weighing sensor is actually a device that converts a mass signal into a measurable electrical output. The force sensor is a device that converts the force value into an electrical signal. Difference 1: The weight sensor only measures the weight, and only the direction of the gravitational field. And the weight is always going to be greater than 0. If a container is placed under a weighing sensor, it does not produce a weight in the op...
English
Français
Español